Hello,
i'm trying to configure my network card but i am unsuccessful. Its an AP9630 and i am connected with a serial cable to 2.5 jack. i open a hyperterminal or putty sessions with baudrate 9600 no parity, 8 data bits, 1 stop bit, and no flow control.
when i press a few times enter i get asked for a username. but after few seconds the interface shows weird symbols and i cannot continue. also i need to try a lot before i can try to relogin but the same thing happends. i can hardly enter 2 or 3 chars and then i see the strange symbols again.
what can i do about this? i allready switched pc, different serial to jack cable and have this issue in putty as in hyperterminal. also tried usb to serial cable in between. but same issue.
kind regards
w