Hi there,
I have been reading some of the articles here and I think I have a novel problem at hand.
We have 2x9130 1500T USVs, out of which one suddenly died on us. And by "died" I mean the following:
When you press the start button, the unit shows "UPS starting...", then after some minute or so, the red error LED is on. However, there is no entry in the event log, other than ""On" Button pressed". Local Eaton reps were a bit stumped, when I put this forward to them, about a year ago, and suggested replacing batteries, which I did - same issue. I also updated the firmware to the latest version. I planned to use the replacement batteries in our other USV, but found them to be utterly gone after a year of sitting in the shelve, so I got a new set. Gave it a try again, same issue.
[Edit] System test in LanSafe works fine (Passed), but the...