I received a like new UPS from my employer. It was briefly used before being shelved in favor of a higher runtime system as far as they were aware, it functioned fine. I have hooked it up in my home rack, and discovered that while the main 4 outlets work fine, the 4 outlets between groups 1 and 2, appear to be dead. The control panel shows Group 1 and 2 as on. When i connect to the web portal the groups appear to be fine. I put a multimeter to the leads coming off what i assume to be the control board (the circuit board that the power wires come off of for the main outlets, and both groups) and i get a good reading for the main outlets, but nothing for either of the groups. I have tried a Factory reset, and also updating the firmware to the newest version. Are these outlets typically off/disabled by default, and if so, would it not...
↧